197-7909 engine intermediate transmission shaft CAT spare part

Short Description:

185-8902 CAT rear half shaft, heavy-duty rear drive axle shaft with total length of 3613.5 mm. It is used in rear axle assembly of large mining dump trucks, transmits torque from differential to rear final drive, bears heavy vehicle load and ensures rear wheel power output.


Product Detail

Product Tags

description

This CAT shaft is integrally forged from high-strength alloy steel. Journals and mating surfaces are precision ground and quenched with tight tolerance. It is installed inside engine gear housing, receives torque from upstream gears and transmits power to downstream assemblies. It withstands alternating torsion, radial impact and engine oil scouring, stabilizes meshing clearance and reduces runout and uneven wear, lowering power loss. It serves as overhaul replacement part for CAT engine transmission system.

Part number: 197-7909
Brand: CAT
Type: engine intermediate transmission shaft
Material: Corrosion Preventative Fluid, Carbon Steel
Processing: one-piece forging, journal precision grinding, surface quenching, anti-rust and wear-resistant treatment
Matching parts: drive gear, bearing, oil seal, retaining ring, locating key

Advantages:

1. Hardened journals, torsion and wear resistant, anti-scoring under long continuous transmission
2. High shaft concentricity with low runout, reduces abnormal transmission noise and oil seal leakage risk
3. Good material toughness, resistant to alternating impact load and hard to twist or fracture
4. OEM specification, direct replacement and high compatibility with original gears and bearings

FAQ 

Q: What faults will be caused by worn or deformed shaft?
A: Unstable power transfer, abnormal engine transmission noise, gear jam and broken gear, power cut-off in severe cases.

Q: Can this shaft be purchased separately?
A: It is an individual spare part available for separate purchase.

Q: Is it recommended to replace oil seal together?
A: Replacement is recommended. Aged old seals are prone to leakage after reassembly.

Q: Where does wear mainly occur?
A: Journals mating with bearings and oil seals, gear supporting section.

our warehouse

our warehouse

Pack and ship

Pack and ship




  • Previous:
  • Next:

  • Write your message here and send it to us