201003341 baffle for XCMG RP705 paver spare parts

201003341 baffle for XCMG RP705 paver spare parts Featured Image
  • 201003341 baffle for XCMG RP705 paver spare parts

Short Description:

Part No. 201003343, bearing cover, fits XCMG RP705 medium crawler paver. It is the end cover matched for the bearing housing of feeding drive shaft.

Product Detail

Product Tags

description

This retaining plate is stamped from high-quality spring steel plate, quenched and tempered for stress relief with flat surface and excellent toughness and fatigue resistance. As an internal axial protection part inside feeding drive shaft assembly, it cooperates with bearing cover, shaft sleeve and bearing to build a complete limiting structure. It absorbs reciprocating impact during paving, shares locking load and provides secondary protection. It can stop internal parts from sliding outward even if the nut loosens. It fits both left and right feeding drive shaft assemblies of RP705 paver and works long-term under heavy dust and alternating vibration. During bearing housing disassembly, bearing replacement or shaft sleeve overhaul, the retaining plate must be removed for inspection of flatness and mounting holes.

product parameters

- Part Number：201003341
- Name：Retaining Plate
- Applicable Model：XCMG RP705 Medium Crawler Paver
- Matching Parts：Bearing Housing (201003348), Bearing End Cover (201003343), Shaft Sleeve (201003344), Bearing
- Material：Spring Steel Plate
- Function：Axial limiting, absorb axial impact, prevent component loosening

Applicable Scenarios

Installed inside the bearing housings of left and right feeding drive shafts on XCMG RP705 paver. Widely used in asphalt paving projects including municipal roads, expressways, factory pavements and airport runways. It runs continuously with feeding transmission mechanism, resists grit dust and high-frequency vibration impact, and keeps stable axial position of the whole supporting assembly.

advantage

▪ Heat-treated spring steel maintains stable elasticity and resists permanent deformation under long-term vibration
▪ Integrally stamped to OEM tolerances with outstanding interchangeability
▪ Combined limiting with bearing cover and spacer provides double protection and reduces the risk of component slipping out
▪ Balanced plate strength absorbs transient axial impact and protects bearings and shaft sleeves
▪ Easy to disassemble and inspect, common spare part for drive shaft overhaul kits with low stocking cost

FAQ

Q: Can a slightly deformed retaining plate be reused after manual straightening?
A: Straightening for reuse is not recommended. Bending damages the internal structure of spring steel and weakens elasticity, raising failure risk under vibration; replacement is preferred.

Q: Can this retaining plate be omitted as long as the lock nut is tightened?
A: It cannot be omitted. Continuous paving vibration may loosen the nut. The retaining plate is an independent safety limit and indispensable for transmission.

Q: Can an intact-looking retaining plate be kept during overhaul?
A: It may be reused if flat, crack-free and without stretched holes. Replace it if indentations or fatigue marks are visible.

Q: What symptoms indicate retaining plate failure?
A: Axial shifting of bearings and shaft sleeves, louder operating noise, rapid seal failure and oil leakage. In severe cases, internal supporting parts shift and seize and stop the feeding system.

our warehouse

our warehouse

Pack and ship

Pack and ship


  • Previous:
  • Next:
    • Write your message here and send it to us

    Products categories