201027414 end cap for XCMG RP705 paver spare parts

Short Description:

This hex nut M16 with part number 805238777 is an original fastening accessory for XCMG RP705 medium tracked paver.

Product Detail

Product Tags

description

This end cover is cast from ductile iron with good structural rigidity and impact resistance. The sealing surface is precision machined with high flatness, and achieves stable sealing effect when matched with sealing gaskets. The surface is painted for anti-rust, resisting asphalt corrosion and sand abrasion on construction sites. The original positioning hole size is accurate and fully matched with corresponding shaft seat and housing. It is easy to disassemble and install, can isolate impurities for a long time, reduce abnormal wear of internal seals and bearings, and extend the service life of transmission assembly.

product parameters

Part No.:201027414
Product Name:End Cover
Applicable Model:XCMG RP705 Medium Tracked Paver
Material:Ductile Iron
Process:Casting, Precision Machining, Anti-rust Painting
Sealing Type:End Face Sealing (with gasket)
Mounting Method:Bolt Fastening
Matching Parts:Sealing Gasket, Fixing Bolts
Applicable Working Condition:Asphalt Paving, Dust, Muddy Water, Vibration & Impact Environment

Applicable Scenarios

Installed on the end face of shaft cavities such as paver auger shaft and travel drive shaft, used for dustproof, waterproof and sealing protection to protect internal bearings and oil seal assemblies.

advantage

- Ductile iron base material, high rigidity and impact resistance, not easy to crack and deform under vibration
- Precisely machined sealing end face, tight fit, good dust and leakage prevention effect with gaskets
- Anti-corrosion painted surface, resisting asphalt and sand abrasion for harsh site environment
- Accurate original positioning holes, good interchangeability, convenient for disassembly and maintenance
- Effectively block impurities, reduce damage risk of bearings and oil seals, and cut maintenance cost

FAQ

Q: Can the end cover be used after impact deformation?
A: It is not recommended. Deformation will lead to poor sealing, dust and water ingress, and accelerate damage of bearings and oil seals. Replace it.

Q: Does the gasket need to be replaced when installing the end cover?
A: It is recommended to use a new gasket during disassembly and maintenance. Old gaskets are prone to aging and damage, which may cause leakage.

Q: What will happen if the end cover bolts get loose?
A: Loose bolts will cause sealing failure, sand and asphalt entering the cavity, resulting in bearing jamming and oil seal leakage.

Q: Is it necessary to deal with paint peeling?
A: Minor paint peeling can be repainted for rust prevention. If cracks or sand holes cause leakage, replace the end cover directly.

our warehouse

our warehouse

Pack and ship

Pack and ship




  • Previous:
  • Next:

  • Write your message here and send it to us