292-4486 idler power take-off short shaft CAT spare part

Short Description:

134-9441 CAT air shaft, 22.17 mm diameter, rotary shaft for air control valve, controls opening and closing of air passage and adjusts intake air flow.


Product Detail

Product Tags

description

This CAT idler power take-off short shaft is forged from high-strength alloy steel with precision ground journals and tight dimensional tolerance. It is mounted on the power take-off side of engine gear housing, supports idler gear rotation, changes transmission direction and outputs power externally to drive hydraulic pumps and auxiliary equipment. It continuously bears radial load and alternating impact from gear meshing and reduces transmission vibration. It is used for overhaul replacement of power drive system on heavy CAT construction machinery.

Part number: 292-4486
Brand: CAT
Type: idler power take-off short shaft
Outer diameter: 187 mm
Material: Low-alloy steel
Processing: forging, surface quenching, journal precision grinding
Matching parts: idler gear, bushing, oil seal, retaining ring, locating key

Advantages:

1. Hardened quenched surface, wear and fatigue resistant for long heavy-duty power take-off
2. High rigidity with large outer diameter, resistant to bending under meshing impact
3. Precisely machined journals, stable clearance with bushings for quiet and smooth rotation
4. OEM dimension, direct replacement without extra grinding work

• Ensure accurate gear alignment and smooth rotation.
• Resist corrosion and ensure longevity.
• Minimize vibrations and ensure smooth operation.

FAQ 

Q: What faults will be caused by worn idler PTO short shaft?
A: Power output vibration, unstable take-off pressure, gear housing noise, gear tooth breakage and power loss in severe cases.

Q: Can this short shaft be purchased separately?
A: It is an individual spare part available for separate purchase.

Q: Is gear timing check required after replacement?
A: Align gear timing marks to prevent fuel and valve timing deviation.

Q: Where does wear mainly occur?
A: Mating surface between journal and bushing, and gear positioning section.

our warehouse

our warehouse

Pack and ship

Pack and ship




  • Previous:
  • Next:

  • Write your message here and send it to us