486-6738 right hand helical shaft CAT spare part

Short Description:

112-1552 Cat timing gear idler shaft with 106 mm outer diameter, installed in rear gear housing of 3500 series engines, supports idler gear and stabilizes timing phase between crankshaft and camshaft.


Product Detail

Product Tags

description

This one-piece right-hand helical gear shaft is built for Caterpillar transmission system. It is forged alloy steel with quenched and tempered treatment, carburized and hardened gear teeth with precision grinding. It features 20 right-hand helical teeth and installs inside transmission gear housing. Helical teeth reduce shock and noise during meshing. It withstands heavy cyclic torsion load and works in pair with left-hand helical gear. It is widely used in loaders, mining trucks and motor graders. It is replacement part for transmission overhaul and repair of pitting or noisy gear sets.

Part Number:486-6738
Name:Right Hand Helical Shaft
Tooth Count:20 teeth, right hand helical
Material:Alloy structural steel, tempered + carburized hardened teeth
Structure:Integrated gear shaft, helical tooth
Fit Location:Transmission gear housing, right side gear pair

Advantages

• Resistant to wear and fatigue, ensuring reliable long-term performance.
• Withstands continuous rotational stress for extended service life.
• Withstands dynamic loads associated with engine balancing.

1. Alloy steel with carburized teeth, high surface hardness, good pitting resistance, resistant to tooth breakage under heavy load.
2. Right-hand helical design provides high contact ratio, smoother transmission and lower noise than spur gears.
3. One-piece forging ensures good concentricity between gear and shaft, reduces uneven load and bearing stress.
4. OEM tooth profile, matched with designated left-hand gear, direct replacement without changing gear ratio.

FAQ 

Q:Can helical shaft with minor pitting stay in service?
A:Long-term use is not recommended. Pitting propagates and causes spalling, tooth fracture and transmission damage.

Q:Can right-hand helical shaft replace left-hand one?
A:No. Helix angle direction differs. Wrong assembly will cause immediate tooth damage.

Q:Should mating gear be replaced together?
A:Recommended if mating gear is worn. Old and new teeth wear rapidly when paired.

Q:Are helical shafts interchangeable with same tooth count?
A:No. Helix direction, module, pressure angle and length differ, wrong parts cannot mesh properly.

our warehouse

our warehouse

Pack and ship

Pack and ship




  • Previous:
  • Next:

  • Write your message here and send it to us