522-2827 5mm thick camshaft thrust plate CAT excavator spare part

522-2827 5mm thick camshaft thrust plate CAT excavator spare part Featured Image
  • 522-2827 5mm thick camshaft thrust plate CAT excavator spare part
  • 522-2827 5mm thick camshaft thrust plate CAT excavator spare part
  • 522-2827 5mm thick camshaft thrust plate CAT excavator spare part

Short Description:

Part No.522-2827, CAT camshaft thrust plate, 5mm thickness, restricts camshaft axial movement and controls axial clearance, spare part for engine camshaft overhaul.


Product Detail

Product Tags

description

This 522-2827 camshaft thrust plate is fitted between camshaft timing gear and cylinder block. It bears axial thrust to limit forward and backward movement of camshaft and stabilize gear meshing position to prevent timing shift. Made of precision machined medium carbon steel plate with heat treated surface for wear resistance, anti-extrusion and anti-deformation. It fits multiple CAT diesel engine camshaft assemblies, an inspection wearing part for timing overhaul.

Part No.：522-2827
Name：CAT 5mm thick camshaft thrust plate
Thickness：5mm
Material：Carbon Steel
Treatment：Surface grinding & heat treatment
Function：Camshaft axial limiting and clearance control
Application：CAT 320D3 GC 320D3 excavator

Advantages

• Provided with 2 mounting holes to fit a fastener of size M8.
• Manufactured to precise specifications and are built for durability, reliability, and productivity.

1. Precise thickness tolerance for axial clearance calibration, keep camshaft end play within OEM range
2. Smooth friction surface, lower sliding resistance and less heat wear
3. Balanced plate toughness, resistant to fracture and warping under alternating axial load
4. Replace together while removing timing gear, prevent timing jump and noise caused by worn old plate

FAQ 

Q1：What fault will happen if 522-2827 thrust plate wears thin?
A：Excessive camshaft axial play, unstable gear meshing, abnormal noise, even timing jump and valve bending.
Q2：Can we grind the thrust plate surface to adjust clearance?
A：Not recommended. Grinding will remove hardened wear layer and cause rapid failure.
Q3：Can we stack multiple 522-2827 plates to fix large axial clearance?
A：No. This is standard thickness thrust plate. Use special adjusting shims for clearance correction.
Q4：Is there a front and back side for installation?
A：The smooth wear-resistant face should face timing gear, do not reverse.

our warehouse

our warehouse

Pack and ship

Pack and ship


  • Previous:
  • Next:
    • Write your message here and send it to us

    Products categories