7C-7851 front gear shaft CAT spare part

Short Description:

4W-6702 CAT magneto drive gear shaft, integrated drive gear, takes power from engine gear train to rotate magneto and supply timed power for ignition system.


Product Detail

Product Tags

description

This CAT front gear shaft is forged from high-strength alloy steel with precision ground fitting journals. It is installed in the engine front gear housing as the main support spindle for front gear group. It supports the idler gear for meshing transmission, receives power from crankshaft gear and distributes torque to drive front accessories such as oil pump and fuel pump. It continuously bears radial load and alternating impact from gear meshing, suitable for engine overhaul replacement of CAT C12, C13 and other models.

Part number: 7C-7851
Brand: CAT
Type: front gear shaft
Height (mm): 51.8
Diameter (mm): 72.0
Material: Low Alloy Steel
Processing: forging, surface quenching, journal precision grinding
Matching parts: idler gear, bushing, retaining ring, oil seal
Applicable models: C12, C13, 621K, 627H, 623K, 572R II

Advantages:

1. Hardened journals, wear and fatigue resistant for long continuous front gear transmission
2. Precisely machined shaft diameter, uniform clearance with bushings for smooth rotation and low noise
3. High overall rigidity, resistant to bending under heavy meshing load
4. OEM dimension standard, direct replacement and convenient for gear timing calibration

• Supported by bearings, which reduces friction and ensures smooth operation.
• Lubricated by transmission fluid, helping to minimize wear.
• Enables efficient and reliable vehicle operation.

FAQ 

Q: What faults will be caused by worn front gear shaft?
A: Gear housing abnormal noise, unstable oil pump supply, timing disorder and power loss in severe cases.

Q: Can this front gear shaft be purchased separately?
A: It is an individual spare part available for separate purchase.

Q: Is timing check required after replacement?
A: Gear timing marks must be aligned to avoid deviation of valve and fuel supply timing.

Q: Where does wear mainly occur?
A: The mating surface between journal and bushing, and gear meshing contact surface.

our warehouse

our warehouse

Pack and ship

Pack and ship




  • Previous:
  • Next:

  • Write your message here and send it to us