252101526 bracket for XCMG ZL50G/ZL50GL Wheel Loader

product parameters

Part No：252101526
Product Type：Control Cable Fixing Bracket
Applicable Equipment：XCMG ZL50G / ZL50GL 5 Ton Wheel Loader
Core Technology：Steel plate stamping welding, stress relief treatment
Material：Q235 thick carbon steel plate
Surface Treatment：Sandblasting + epoxy anti-rust paint
Mounting Hole Quantity：3 mounting holes
Hole Diameter：12.5mm
Overall Dimension：215mm × 120mm × 85mm
Soft shaft groove width：22mm
Allowable Dynamic Load：950N
Working Temperature Range：-30℃ ~ +70℃
Installation Method：Bolt fixed assembly
Application：Guide and fix operating control cable, limit cable bending radius

• Thick steel plate plus reinforcing rib design, high structural rigidity, resist long-term vibration fatigue on construction sites.
• Built-in cable limiting groove, control the minimum bending radius of soft shaft, prevent sharp bending and reduce internal steel wire wear.
• Stress relief welding process eliminates internal welding stress, reduce the risk of weld cracking under repeated impact vibration.
• Sandblasting and epoxy anti-rust coating, good corrosion resistance, adapt to muddy, dusty outdoor construction environment.
• Precise hole position and groove size, fully consistent with OEM specifications, easy bolt alignment during replacement.
• Protect the control cable, reduce cable shaking and friction, extend service life of the operating soft shaft, reduce the frequency of cable maintenance and replacement.

FAQ 

Q1：Which loader does 252101526 soft shaft bracket fit?
A1：It is designed for XCMG ZL50G and ZL50GL wheel loaders. Confirm machine serial number before purchase to avoid wrong part selection.

Q2：What signs indicate the soft shaft bracket needs replacement?
A2：Visible cracks or deformation on bracket, weld fracture, mounting hole corrosion and hole enlargement. Damaged bracket will lose limiting function, soft shaft will swing freely, easily leading to premature damage of control cable.

Q3：What should be noted during bracket installation?
A3：Clean the frame mounting surface, use matched high-strength bolts and spring washers. Tighten bolts diagonally. Ensure the soft shaft inside the groove keeps reasonable slack, avoid over-tension. Recheck bolt tightness after 2~3 hours of operation.

Q4：What causes bracket damage?
A4：Long-term alternating vibration fatigue; impact collision; mud and rainwater corrosion; bolt loose, which increases extra stress on bracket.

Q5：Can cracked bracket be welded for reuse?
A5：Not recommended. Welding repair will change local material stress state, it is easy to crack again under vibration impact. Once the bracket fails, the soft shaft loses limit and may be damaged quickly. Better replace with new bracket.

Q6：How to maintain the soft shaft bracket daily?
A6：Regularly check bracket surface for cracks and rust, inspect bolt tightness. Clean mud and dust on the bracket and soft shaft regularly to slow down corrosion.