252101812 side tooth for XCMG ZL50G/ZL50GL Wheel Loader

product parameters

Product Name: Right Side Bucket Tooth
Part No.: 252101812
Applicable Model: XCMG ZL50G, ZL50GL Wheel Loader
Material: High-chromium wear-resistant alloy with quenching and tempering treatment
Function: Right cutting wear part of bucket, cut into materials and protect bucket lip
Matching parts: tooth adapter, lock pin, circlip
Working condition: Combined impact and friction load
Inspection Items: Dimension inspection, hardness test, casting defect detection, mounting slot fit verification

Applicable Scenarios

Installed on the right end of bucket cutting edge, forming cutting group with other teeth. Used for digging soil, sand and gravel in aggregate yards, earthwork sites and stock yards, suitable for general earthmoving and loose rock loading.

- Original design with precise slot and positioning size, tight fit with tooth adapter, stable installation against falling off
- High-chromium alloy casting and heat treatment, balanced hardness and toughness, resist chipping and breaking when digging gravel
- Streamlined cutting tip reduces digging resistance and lowers machine load
- Individual replacement design, no need to change whole bucket or lip, save cost
- Strict control of casting defects to avoid sudden fracture during operation
- Extra wear allowance for corner position, suitable for side scraping and angled digging
- Fully compatible with ZL50G / ZL50GL bucket, adapter, pin and circlip, easy to install
- Low-investment fast-wearing part, convenient for dealers and service shops to stock

FAQ 

Q：What happens when the right side tooth is worn or broken?
A：Poor penetration and slipping on the right corner, higher digging load. The unprotected bucket lip is directly abraded and easily rolled and deformed.

Q：Difficult digging always means this right tooth is damaged?
A：No. Worn left or middle teeth and hard materials also affect digging. Check adapter and lock pin condition before replacement.

Q：Can a tooth with small chip keep working?
A：Minor chip is acceptable for short-time use. Replace it immediately if crack appears at root, otherwise it may break suddenly and damage tooth adapter.

Q：Can left tooth and right tooth be swapped?
A：Not interchangeable. They are symmetrical special-shaped parts with different cutting angle. Wrong assembly causes loose fit and poor digging performance.

Q：What should be noticed when replacing this right tooth?
A：Clean dirt and rust inside adapter seat. Replace damaged adapter together. Fit tooth into slot, install lock pin and circlip, check looseness and test digging.

Q：What accelerates tooth damage?
A：Digging sharp hard rock, hitting obstacles with tooth, working without lock pin and heavy side scraping on hard ground.

Q：Is mechanism adjustment needed after replacement?
A：No adjustment required for same part number replacement. Repair or replace deformed adapter seat if loose fit persists.