4W-4997 gear group shaft CAT spare part

Short Description:

7C-6697 Cat engine idler drive shaft for 3406 series engines, 158.75 mm outer diameter, mounted in gear housing, supports and transmits power to maintain correct timing gear phase.


Product Detail

Product Tags

description

This gear group shaft is built for Caterpillar engine gear housing. It is forged alloy steel with quenched and tempered treatment, precision ground surface and built-in oil passage. It is assembled with drive gear and bushing. It carries cyclic radial and torsion load during gear meshing, stabilizes gear backlash and transmits power. It is widely used on loaders, dozers and generator sets. It is replacement part for gear assembly overhaul and repair of noisy gears or seized bushing.

Part Number:4W-499
Name:Gear Group Shaft
Outer Diameter:108 mm
Material:Low Alloy Steelsurface hardening
Structure:With internal oil passage, precision ground shaft surface
Mounting Position:Inside engine gear housing

Advantages

• Enhances the overall smoothness and efficiency of the engine.
• Ensures smooth and accurate engagement with the cluster gear.

1. Forged alloy steel with surface hardening, good wear and impact resistance, resistant to bending under cyclic load.
2. Internal oil passage delivers pressurized lube oil to shaft and bushing interface to prevent seizure.
3. Precision machined shaft with good concentricity, smooth gear rotation and reduced noise and uneven wear.
4. OEM dimension for direct replacement, keeps original gear backlash and transmission ratio.

FAQ 

Q:Can slightly scored gear group shaft stay in service?
A:Not recommended. Scoring accelerates bushing wear, causes excessive backlash and timing jump.

Q:Must I replace bushing together with gear group shaft?
A:Recommended. Shaft and bushing form friction pair. Old bushing with new shaft causes abnormal clearance.

Q:What failure will blocked oil passage cause?
A:Loss of lubrication leads to rapid seizure of shaft and bushing and broken gears.

Q:Can gear shafts with same outer diameter interchange?
A:No. Total length, oil hole position and locating structure differ, wrong fit causes gear misalignment

our warehouse

our warehouse

Pack and ship

Pack and ship




  • Previous:
  • Next:

  • Write your message here and send it to us