803594842 Speed ​​sensor for XCMG RP705 paver spare parts

Short Description:

Shaft seal (oil seal) is a radial rotary shaft seal, composed of metal frame, rubber lip and garter spring. It is used on paver motors, reducers, sprocket shafts and pump shafts to stop lubricant leakage and block sand, dust and water from entering bearing housing.

Product Detail

Product Tags

description

This speed sensor adopts magnetoelectric or Hall effect structure, consisting of sensing probe, housing and waterproof connector. It detects rotation without direct contact with gear ring and generates pulse signals. The controller calculates real-time travel speed based on pulse frequency to maintain constant paving speed and improve road smoothness. It is vibration-resistant, dustproof and waterproof, suitable for high-temperature and muddy chassis environment. It is a key electronic component of travel control system. Faults may lead to inaccurate speed reading, alarm or unstable paving speed.

product parameters

Part No.:803594842
Product Name:Speed Sensor
Signal Type:Magnetoelectric / Hall pulse signal
Housing Material:High-strength engineering plastic + metal probe
Connector:Waterproof plug
Function:Speed acquisition, travel speed feedback

Applicable Scenarios

Installed on paver travel motor or reducer output end to collect track speed signal, feed back speed data to controller for constant-speed paving, speed display and fault alarm.

advantage

▪ Non-contact magnetic sensing, no wear and long service life
▪ Waterproof and dustproof connector, reliable under vibration and muddy site conditions
▪ Stable signal output, keeps constant paving speed for better road smoothness
▪ Adjustable installation gap, easy to fit and replace
▪ Original matched part, compatible with electric control system, plug and play

FAQ

Q:What are common symptoms of faulty speed sensor?
A:No speed display, fluctuating speed, failed constant speed, error code and uneven paving.

Q:What is the proper gap between probe and gear ring?
A:Keep proper clearance. Too large gap causes signal loss; direct contact will damage the sensor.

Q:Can I short-circuit the sensor for testing?
A:Not recommended. It may damage controller port. Use multimeter or diagnostic tool to check pulse signal.

Q:What happens if cable sheath is broken and water enters?
A:Signal interference and intermittent speed fault. Check plug seal and wiring harness first.

Q:Can magnetoelectric sensor replace Hall sensor?
A:No. Power supply and signal logic are different. Replace with the same part number.

our warehouse

our warehouse

Pack and ship

Pack and ship




  • Previous:
  • Next:

  • Write your message here and send it to us