200635109 Washer for XCMG RP705 paver spare parts

Short Description:

Latch Pin Assembly, Part No.201000294, is a hinged locking assembly for XCMG RP705 medium crawler paver. It consists of pin shaft, retaining ring and cotter pin.

Product Detail

Product Tags

description

This washer is stamped from carbon steel plate with flat surface and uniform dimension. Installed between bolt head/nut and workpiece, it spreads fastening pressure and protects surface from damage, and helps resist loosening caused by vibration. After long service, it may flatten, crack or thin due to rust. Failed washer leads to loose bolts and surface damage, so replacement is required.

product parameters

Part No.:200635109
Product Name:Washer
Material:Carbon steel
Processing:Stamping
Working Condition:Continuous vibration, impact load, high temperature and dust
Function:Distribute fastening pressure, protect workpiece surface and assist anti-loosening

Applicable Scenarios

Used on brackets, pull rods, auger guards and hinge supports of XCMG RP705 paver. Replace when flattened, cracked or heavily rusted.

advantage

▪ OEM standard size, perfectly matched with corresponding bolts
▪ Flat surface for even pressure distribution
▪ Anti-rust treatment for harsh paving site environment
▪ Compact and easy to install for various fastening positions
▪ Low cost to protect expensive brackets and plates

FAQ

Q:Can flat washers and spring washers be used together?
A:Yes. Flat washers protect surfaces while spring washers provide anti-loosening effect.

Q:Is there a front or back side for flat washers?
A:No. Just keep the flat side against the workpiece.

Q:Can I tighten nuts without washers?
A:Not recommended. Concentrated pressure will damage parts and bolts loosen easily.

Q:Can washers of different sizes be mixed?
A:No. Mismatched size causes offset and insufficient bearing area. Match by part number.

our warehouse

our warehouse

Pack and ship

Pack and ship




  • Previous:
  • Next:

  • Write your message here and send it to us