252904851 bucket assembly(for light material) for XCMG ZL50G/ZL50GL Wheel Loader

product parameters

Product Name: Light Material Bucket Assembly
Part No.: 252904851
Applicable Model: XCMG ZL50G, ZL50GL Wheel Loader
Bucket Type: High-volume light-duty bucket
Capacity: 4.5m³
Main Material: Light wear-resistant steel plate
Matching Parts: Light bucket teeth, edge plate, bolt kits
Connection: Articulated connection with boom and tilt cylinder via pins
Working Condition: Fly ash, grain, wood chips, straw fragments, sand and other low-density bulk materials
Inspection Items: Dimension inspection, ultrasonic weld test, lug hole concentricity test, surface defect inspection

Applicable Scenarios

It matches XCMG ZL50G and ZL50GL loaders, widely used in grain depots, biomass power plants, feed mills and fly ash yards for grain, bran, wood chips, straw and dry sand. It is optimized for light bulk materials. Heavy quarrying and rock digging are not recommended, which may cause bucket deformation and weld cracking.

- OEM lug dimensions fully compatible with ZL50G/ZL50GL, direct hoist replacement without modification
- Large cavity design increases payload per pass and improves light-material throughput
- Light plate construction reduces tare weight, maximizes effective payload and saves fuel
- Streamlined bucket profile ensures clean dumping and less powder residue
- Reinforcing ribs on stress areas provide reliable fatigue resistance for continuous light-duty cycles
- Light teeth and edge plate are easy to replace with low maintenance cost
- Interchangeable with rock bucket and general bucket for quick work condition switching

FAQ 

Q：Can this light material bucket be used for rock and ore?
A：Not recommended. It uses thin lightweight plate without heavy rock bucket reinforcement. Rock impact causes denting, weld cracking and deformation. It is only for low-density loose materials.

Q：Can light bucket and rock bucket be swapped directly?
A：Lug geometry is identical for direct swapping. But working condition must match. Control payload after bucket change and never overload the machine.

Q：How to handle worn cutting edge plate?
A：The edge plate is a wear part. Replace it separately when worn or curled. Light teeth can be fitted optionally.

Q：How to reduce powder residue for grain and fly ash?
A：The streamlined liner helps dumping. Raise dumping height and curl slowly to reduce adhesion. Clean the bucket regularly.

Q：Can side plate cracks be repaired by welding?
A：Grind out the crack root completely before welding with matching consumables. Cracks near ribs or lugs are high-stress; reduce payload after repair.

Q：What to check during new bucket installation?
A：Hoist gently to avoid damage. Align lugs without hammering pins violently. Fit cotter pins correctly and test empty cycles before loading.