252904853 blade for XCMG ZL50G/ZL50GL Wheel Loader

product parameters

Product Name: Replaceable Cutting Edge for Light Material Bucket
Part No.: 252904853
Applicable Model: XCMG ZL50G, ZL50GL Wheel Loader
Matching Parts: 252904851 light material bucket
Material: Wear-resistant structural steel
Process: Cutting and chamfering
Matching parts: High-strength bolts, flat washers, spring washers
Installation: Bolted onto bucket cutting edge
Working Condition: Fly ash, grain, wood chips, straw fragments, dry sand and other light bulk materials
Inspection Items: Dimension inspection, hardness sampling, hole position tolerance check, surface defect inspection

Applicable Scenarios

It is used with 252904851 light material bucket on XCMG ZL50G and ZL50GL loaders, widely used in grain depots, feed mills, biomass yards, fly ash and dry sand stockpiles. It is suitable for fluffy loose bulk materials without hard lumps, and not for rock, stone and high-impact materials.

- OEM hole layout and curve match 252904851 bucket closely without assembly interference
- Lightweight wear-resistant plate optimized for abrasive light materials, with minimum extra dead weight
- Bolt-on design for individual replacement, eliminating bucket edge welding repair
- Chamfered surface enables smooth penetration and cleaner scraping with less material sticking
- Low-cost spare part, easy to stock and fast to replace on site
- Good durability in dusty grain and powder yards, resistant to edge curling
- Matched with full set of light bucket components for simple spare part management

FAQ 

Q：Can this replaceable cutting edge be installed on rock bucket?
A：Not recommended. Its thickness and strength are designed for light abrasion only. Rock impact will cause rapid chipping and deformation. Rock buckets require heavy-duty edge protectors.

Q：Can curled edge plate stay in service?
A：Minor curling is acceptable for short-term use. Replace it if heavily curled, thinned or cracked, otherwise scraping performance drops and the bucket base edge will wear.

Q：What causes loose bolts?
A：Dirt on mating surface, old spring washers and insufficient torque are common causes. Clean contact surface, use new washers, tighten diagonally and recheck regularly.

Q：Can I hardface the edge to thicken it?
A：Repair by welding is not recommended. Welding leads to distortion and unstable performance. Direct replacement is preferred.

Q：Is this edge directional left or right?
A：This full-length main edge is non-directional. Only segmented corner edges require side marking, verify drawing before ordering.

Q：What to check on delivery inspection?
A：Verify part number, check cracks and warping, measure hole spacing and dimensions, inspect chamfer and test fit with bucket edge.