253000506 bucket assembly for XCMG ZL50G/ZL50GL Wheel Loader

product parameters

Product Name: Standard Bucket
Part No.: 253000506
Applicable Model: XCMG ZL50G, ZL50GL Wheel Loader
Material: High-strength wear-resistant steel plate with hard surfacing reinforcement
Function: Front loading assembly for scooping, holding and dumping sand, earth and ore
Matching parts: bucket pin, bushing, bucket tooth, tooth adapter
Working condition: Combined friction, impact and squeeze load
Inspection Items: Overall dimension check, lug hole spacing verification, weld crack detection, cutting edge straightness test

Applicable Scenarios

Mounted on the front of working device, matched with boom and linkage, used for aggregate loading, earth excavation, mine rock transfer and bulk cargo handling, suitable for earth, gravel and ordinary loose materials.

- Original bucket shape and lug layout, fully compatible with ZL50G / ZL50GL tilt linkage and pins
- Reinforced cutting edge and tooth seat with hard surfacing, resist impact and abrasion against rock
- Optimized inner curve, smooth penetration, good material retention and clean dumping
- Robotic welding and stress relief, stable welds, resist cracking under repeated digging impact
- Thickened lugs for load dispersion, reduce lug tearing and rapid bore wear
- Standard tooth seat design, replace teeth separately instead of whole bucket, save maintenance cost
- Balanced structure, stable force during lifting and tilting, reduce machine vibration
- Standard 5-ton loader bucket, widely stocked for general earth and aggregate works

FAQ 

Q：What symptoms occur when the bucket is worn?
A：Worn and rolled cutting edge causes slipping when digging, reduced payload, material sticking during dumping, abnormal shaking and noise. Severe crack brings tearing risk.

Q：Poor digging performance always means bucket damage?
A：No. First check tilt cylinder leakage and linkage bushing clearance. Confirm bucket damage only after eliminating hydraulic and hinge faults.

Q：Can cracked bucket be repaired by welding for long heavy use?
A：Minor weld repair is only for temporary use. Impact will re-open cracks. Replace bucket if cracks are serious.

Q：Can buckets of different capacity or type be interchanged?
A：Not interchangeable. Bucket capacity, lug spacing and weight differ. Wrong fit causes cylinder over-travel and linkage damage. Always confirm part number.

Q：What precautions during bucket installation?
A：Safe lifting operation. Clean dirt on hinge holes. Inspect pins, bushings and dust seals. Assemble gently, inject grease and test full tilt and lifting stroke.

Q：What causes rapid bucket damage?
A：Digging large hard rock, hitting ground or obstacles, working without bucket teeth, and continuing operation after cracks appear.

Q： Is tilt cylinder adjustment required after bucket replacement?
A：No adjustment needed for same part number replacement. Inspect linkage clearance if old bucket deformation caused offset.