331-0291 engine connecting rod CAT spare part

Short Description:

359-0722 CAT engine connecting rod, fits C4.4, 3054C engine. It transfers combustion thrust from piston to crankshaft and converts reciprocating linear motion into rotary torque, serving as core load-bearing component for 313D2, 318D2L, 320GC excavators and 420F backhoe loaders.


Product Detail

Product Tags

description

This CAT connecting rod is die-forged from high-quality alloy steel. The rod body, big end and small end bores are precision bored. The fractured split design of big end ensures stable positioning accuracy. It is suitable for CAT 320D2, 323D2, 326D2, 329D2, 330GC excavators, 950GC, 962M wheel loaders, 120M motor graders and generator sets equipped with C7.1 engine. The small end with bushing connects piston via piston pin, and the big end with bearing shells wraps crankshaft journal. It bears alternating impact, tensile and compressive stress during combustion stroke, and is key overhaul replacement part for C7.1 diesel engine.

Part number: 331-0291
Brand: CAT
Type: engine connecting rod
Fit: C7.1 engine, 320D2/323D2/326D2/329D2 excavator, 950GC/962M wheel loader, 120M motor grader, generator set
Material: Corrosion Preventative Fluid
Processing: die forging, quenching and tempering, precision boring, fractured splitting, oil passage cleaning, anti-rust surface treatment
Matching parts: connecting rod bearing, piston pin, piston pin bushing, connecting rod bolt, rod cap

Advantages:

1. Check rod body for cracks, twisting deformation and out-of-round bores after disassembly. Damaged rods cannot be reused
2. Fully clear lubricating oil passages, remove carbon, sludge and metal debris on split surface
3. Connecting rod bolts are single-use parts, must be renewed for overhaul and tightened step by step to CAT specified torque
4. Check rod side clearance after assembly, monitor oil pressure and knocking noise during test run

FAQ 

Q: What faults will be caused by damaged connecting rod?
A: Connecting rod knocking noise and low oil pressure. In severe cases, broken rod penetrates cylinder block and destroys crankshaft, leading to total engine failure.

Q: Can this connecting rod be purchased separately?
A: It can be purchased separately. Replace rod, bearings and bolts together for the same cylinder during overhaul.

Q: Is it recommended to replace connecting rod bearings together?
A: Yes. Worn old bearings have excessive clearance and may cause bearing seizure.

Q: Where does failure usually occur?
A: Transition fillet of rod body, big end split area and stress zone of bolt holes.

our warehouse

our warehouse

Pack and ship

Pack and ship




  • Previous:
  • Next:

  • Write your message here and send it to us