252904836 bucket assembly(for light material) for XCMG ZL50G/ZL50GL Wheel Loader

product parameters

Product Name: 5.0m³ Light Material Bucket Assembly
Part No.: 252904836
Applicable Model: XCMG ZL50G, ZL50GL Wheel Loader
Bucket Type: High-volume light-duty bucket
Capacity: 5.0m³
Main Material: Light wear-resistant steel plate
Matching Parts: Replaceable cutting edge, high-strength bolts, flat washers, spring washers
Connection: Articulated connection with boom and tilt cylinder via pins
Working Condition: Fly ash, grain, wood chips, straw fragments, dry sand and other low-density bulk materials
Inspection Items: Dimension inspection, ultrasonic weld test, lug hole concentricity test, surface defect inspection

Applicable Scenarios

It matches XCMG ZL50G and ZL50GL loaders, widely used in grain depots, biomass power plants, feed mills, fly ash yards and dry sand stockpiles for grain, bran, wood chips and straw fragments. It is only for loose light materials without hard lumps. Rock quarrying, hard rock digging and heavy construction waste mixture are forbidden, which will cause deformation and weld tearing.

- OEM lug dimensions fully compatible with ZL50G/ZL50GL, direct hoist replacement without linkage modification
- Large 5.0m³ cavity improves single-pass payload and light-material throughput significantly
- Light plate design reduces dead weight, maximizes effective payload and optimizes fuel consumption
- Streamlined liner for clean dumping and less powder adhesion, saving cleaning time
- Compatible with replaceable cutting edge, low maintenance cost and short downtime
- Reinforced high-stress areas provide reliable fatigue resistance for long continuous light-duty cycles
- Shared mounting interface with 3m³ earth bucket, 3m³ rock bucket and 4.5m³ light bucket for fast switching

FAQ 

Q：Can this 5.0m³ bucket carry gravel mixture and crushed stone?
A：Not recommended. It is lightweight for light bulk materials. Repeated impact from gravel will dent the plate and crack welds.

Q：Can 5.0m³ and 4.5m³ light buckets swap directly?
A：They share the same lug geometry. Control payload after swapping. Overloading will endanger machine stability.

Q：How to handle worn and curled cutting edge?
A：The edge is a wear part. Minor curling is acceptable temporarily. Replace it once thinned or cracked.

Q：How to reduce material sticking on bucket liner?
A：Raise dumping height and curl slowly. Clean the bucket regularly. Wet materials stick more easily, handle dry materials first.

Q：Can small side plate cracks be welded?
A：Grind out the crack root completely before welding. Reduce payload after repair if cracks are near lugs or ribs.

Q：What are the installation notes for the new bucket?
A：Hoist gently to avoid damage. Align lugs without hammering pins violently. Install cotter pins and test empty cycles before loading.

Q：What to inspect on delivery?
A：Verify part number, check deformation and weld defects, measure lug dimensions, test-fit matching cutting edge.