252900464 medium transmission shaft for XCMG ZL50G/ZL50GL Wheel Loader

product parameters

Product Name：Intermediate Propeller Shaft
Part Number：252900464
Applicable Model：XCMG ZL50G, ZL50GL Wheel Loader
Shaft Tube Material：Thick wall seamless steel pipe
Universal Joint Material：Alloy steel, carburizing quenching treatment
Structure Composition：Shaft tube, universal joint cross, flange yoke, spline sliding sleeve, grease nipple
Balancing Process：High precision dynamic balance
Connection Method：Flange bolt connection
Installation Method：Bolt fastening, direct replacement
Feature：High torsion resistance, impact resistance, length compensation, low vibration, long service life

- OEM original overall dimension and flange hole layout, fully matches ZL50G/ZL50GL loader installation requirement, bolt-on installation without modification, shorten maintenance replacement time.
- Thick seamless steel tube and forged alloy steel cross shaft, outstanding torsion resistance, withstand frequent torque impact during heavy-load shoveling operation, not easy to twist and fracture.
- Precision spline sliding sleeve design, realize automatic length compensation, absorb frame deformation and displacement change, reduce additional stress of transmission system.
- Complete dynamic balance calibration, effectively reduce vibration and abnormal noise in power transmission, protect rear axle and gearbox components.
- Grease nipple design for convenient periodic lubrication, reduce wear of cross shaft and bearing, extend service life of propeller shaft.
- Complete assembly with flange bolts and lock washers, one-piece delivery, convenient for on-site disassembly and quick replacement.
- Optimized universal joint swing angle, smooth power transfer, reduce impact to rear drive axle, lower the failure rate of main reducer.

FAQ 

Q1: Is this intermediate propeller shaft 252900464 compatible with both ZL50G and ZL50GL?
A1: Yes. This propeller shaft is customized for XCMG ZL50G and ZL50GL wheel loaders. Shaft length, flange specification and universal joint size are universal for the two models.

Q2: What typical symptoms indicate that the intermediate propeller shaft needs to be replaced?
A2: Obvious abnormal knocking and vibration during acceleration and shoveling; serious wear or seizure of universal joint cross; cracks on shaft tube or flange; spline severe wear with large gap; power cut-off caused by shaft fracture.

Q3: What routine maintenance should be carried out for intermediate propeller shaft?
A3: Regularly check shaft tube for cracks and deformation; inspect universal joint for looseness and abnormal clearance; add lithium base grease to grease nipple according to maintenance cycle; check tightness of flange connecting bolts; avoid long-time overload operation.

Q4: Is dynamic balance and torque test carried out before delivery?
A4: Every propeller shaft will pass dynamic balance inspection and torsion load test before leaving factory to guarantee stable performance under rated torque.

Q5: What precautions should be taken during propeller shaft installation?
A5: Mark original assembly position before disassembly to keep phase angle of universal joint; clean flange contact surface and remove dirt and rust; replace old lock washers; tighten flange bolts to specified torque; after installation, test run and check for abnormal vibration and noise.

Q6: What hazards will occur if flange bolts are loose for a long time?
A6: Loose bolts will cause the shaft to shake during operation, resulting in flange cracking, universal joint damage, even shaft breakage, sudden loss of power and machine shutdown.